Inserting a scene from a VCR
(1)Set the POWER switch to VTR.
(2)On the VCR, locate just before the insert start point [a], then press Xto set the VCR to the playback pause mode.
(3)On your camcorder, locate the insert end point [c] by pressing m or M. Then press Xto set it to the playback pause mode.
(4)Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY indicator flashes and the end point of the insert is stored in memory.
(5)On your camcorder, locate the insert start point [b] by pressing m, then press two z REC buttons at same time to set your camcorder to the recording pause mode.
(6)First press X on the VCR, and after a few seconds press Xon your camcorder to start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your camcorder automatically returns to the stop mode.
5
REC
4 ZERO SET | 0:00:00 | |
ZERO SET | ||
MEMORY | ||
| MEMORY |
To change the insert end point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY indicator and begin from step 3.
Note
The picture and sound recorded on the section between the insert start and end points will be erased when you insert the new scene.
When the inserted picture is played back
The picture and sound may be distorted at the end of the inserted section. This is not a malfunction.
To insert a scene without setting the insert end point
Skip step 3 and 4. Press x when you want to stop inserting.
60