Adding an audio sound on a recorded tape

(1) Insert your recorded tape into your camcorder.

(2) Set the POWER switch of your camcorder to VTR.

(3) Locate the recording start point by pressing N. Then press Xat the point where you want to start recording to set your camcorder to playback pause mode.

(4) Press AUDIO DUB on the Remote Commander .

(5) Press Xon the Remote Commander and at the same time start playing back the audio you want to record.

The new sound is recorded in stereo 2 (ST2) during playback.

(6) Press x on the Remote Commander at the point where you want to stop recording.

Editing

Monitoring the new recorded sound

To play back the sound

Adjust the balance between the original sound (ST1) and the new sound (ST2) by selecting AUDIO MIX in the MENU settings (p. 72).

VTR SET

H i F i SOUND

AUD I O M I X

RETURN ST1

ST2

[MENU] : END

Five minutes after when you disconnect the power source or remove the battery pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The factory setting is original sound only.

63