Other Functions
Adjusting initial settings | 3 Press a or b to set the clock. | ||
|
| Pressing a will increase the selected hour or | |
1 | minute. Pressing b will decrease the selected | ||
hour or minute. | |||
|
| ||
|
|
|
Section
07
English
Using the initial settings, you can customize various system settings to achieve optimal per- formance from this unit.
1Function display Shows the function status.
1Press SOURCE and hold until the unit turns off.
2Press SOURCE and hold again until the clock appears in the display.
3Press FUNCTION to select one of the in- itial settings.
Press FUNCTION repeatedly to switch be- tween the following settings:
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding down SOURCE until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1Press FUNCTION to select clock.
2Press c or d to select the segment of the clock display you wish to set.
As you select segments of the clock display the segment selected will blink.
Switching the auxiliary setting
Auxiliary equipments connected to this unit can be activated individually. Set each AUX source to ON when using. About connecting or using auxiliary equipments, refer to Using the AUX source on the next page.
1Press FUNCTION to select AUX1/AUX2.
2Press a or b to turn AUX1/AUX2 on or off.
Setting the rear output and subwoofer controller
This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker
Initially, the unit is set for rear
1Press FUNCTION to select
2Press a or b to switch the rear output setting.
Pressing a or b will switch between
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select
# When a subwoofer is connected to the rear output, set for subwoofer
En 23