Sony DEH-P2900MP Other Functions, Turning the clock display on or off, Using the AUX source

Section

07 Other Functions

# When the rear output setting is R-SP :S/W,	About AUX connection method
you cannot operate the following procedure.	You have two methods to connect auxiliary

3Press c or d to switch the subwoofer output or rear output.

Pressing c or d will switch between P/O :S/W and P/O :FUL and that status will be displayed.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 21).

!If you change this setting, subwoofer output

in the audio menu return to the factory settings.

Turning the clock display on or off

You can turn the clock display on or off.

%Press CLOCK to turn the clock display on or off.

Each press of CLOCK turns the clock display

on or off.

# The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds.

Note

Even when the sources are off, the clock display appears on the display. Pressing CLOCK turns the clock display on or off.

equipments to this unit.

Stereo mini pin plug cable (AUX1)

When connecting auxiliary equipment using a stereo mini plug cable

%Insert the stereo mini plug into the AUX input jack on this unit.

IP-BUS-RCA interconnector (AUX2)

When connecting auxiliary equipment using an IP-BUS-RCA Interconnector (sold separately)

%Use an IP-BUS-RCA Interconnector such as the CD-RB20/CD-RB10 (sold separetely) to connect this unit to auxiliary equipment featuring RCA output.

For more details, refer to the IP-BUS-RCA Inter-

connector owner’s manual.

# You can only make this type of connection if the auxiliary equipment has RCA outputs.

Selecting AUX as the source

%Press SOURCE to select AUX (AUX1 or AUX2) as the source.

Press SOURCE until AUX appears in the dis-

play.

# If the auxiliary setting is not turned on, AUX

cannot be selected. For more details, see Switch- ing the auxiliary setting on the previous page.

Using the AUX source

This unit can control up to two auxiliary equip- ments such as VCR or portable devices (sold separately). When connected, auxiliary equip- ments are automatically read in as AUX sources and assigned to AUX1 or AUX2. The relationship between AUX1 and AUX2 sources is explained below.

Introduction of iPod® operation

1

You can use this unit to control an iPod adapter, which is sold separately.

24 En