Sony DHC-MD5 Timer-recording radio programmes contined, Set the time to start recording

Timer-recording radio programmes (contined)

5 Set the time to start recording.

Turn MULTI JOG to set the hour, then press ENTER/YES.

The minute indication starts flashing.

Turn MULTI JOG to set the minute, then press ENTER/YES.

The hour indication flashes again.

6 Set the time to stop recording following the above procedure.

7 Turn MULTI JOG and select “TUNER to MD.”

8 Press ENTER/YES.

The start time, followed by the stop time, preset number and the recording source appears, then the original display appears.

9 Insert a recordable MD.

10 Turn off the power.

40

To check the setting

Press TIMER SELECT repeatedly until “REC TIMER” appears. The start time, followed by the stop time and the preset number appears, then the original display appears. To change the setting, start again from step 1.

To cancel the timer operation

Press TIMER SELECT repeatedly until “TIMER OFF” appears.

Tip

When you connect a tape deck as the TC-TX5 equipped with an AU BUS connector to the system, you can activate the timer-recording with the tape deck.

Notes

•Do not operate the system from the time the power turns on until the recording starts (about 20 seconds).

•When you use the blank MD to record, the first 15 seconds will not be recorded.

•If the power is on at the preset time, the recording will not be made.

•The volume is reduced to minimum during recording.

DHCMD5 3-858-047-12.EN (1)