Connecting to an amplifier equipped with a Dolby Pro Logic Surround

Dolby Pro Logic Surround

You can still enjoy the excitement of Surround Sound even if your A/V receiver does not offer Dolby Digital decoding.

If your A/V receiver has a Dolby Pro Logic ll/ Pro Logic decoder, refer to the following connection diagram.

You must set the LINE SELECT switch to the "Out" mode

Right side of unit

 

IN OUT

Amplifier equipped with a

VOLUMEPHONES

VIDEO LINE SELECT

Dolby Pro Logic Surround

To AUDIO IN/OUT

To VIDEO

To analog

 

IN/OUT

audio input

 

 

Front speaker (right)

Center speaker

Front speaker (left)

Rear speaker (right)

Rear speaker (left)

Audio/Video cable

(yellow)

(Supplied)

No need to connect

 

when using an S-video cable

 

to connect to your TV.

Connect one or two rear speak- ers. The output sound from the rear speakers will be monaural even if you connect two rear speakers.

With a receiver equipped with Dolby Digital Connect the equipment the same way as described in “Connecting to an amplifier equipped with a Dolby Digital decoder” on the previous page. Refer to that receiver’s owner’s manual and set the receiver so you can enjoy Dolby Pro Logic Surround sound.

NOTE:

Be sure to set Digital Audio Output of this DVD player to “PCM” from the SETUP menu when you enjoy sounds of Dolby Pro Logic Surround using this connection.

Connections

59

Page 59
Image 59
Sony DVP-FX701 operating instructions Dolby Pro Logic Surround, In/Out