Sony DVP-NS76H Setting the digital output signal

◆AUDIO FILTER

Selects the digital filter to reduce noise above

22.05kHz (Sampling frequency (Fs) of the audio source is 44.1 kHz), 24 kHz (Fs is

48 kHz), or 48 kHz (Fs is above 96 kHz).

SHARP Provides a wide frequency range

and spatial feeling.

SLOW Provides smooth and warm sound.

Note

There may be little effect by changing the digital filter depending on the disc or playback environment.

◆DOWNMIX (DVD VIDEO/DVD-VR mode only)

Switches the method for mixing down to 2 channels when you play a DVD which has rear sound elements (channels) or is recorded in Dolby Digital format. For details on the rear signal components, see “Checking the audio signal format” (page 41). This function affects the output of the following jacks:

– LINE OUT L/R (AUDIO) jacks

– LINE (RGB)-TV jack

– DIGITAL OUT (OPTICAL or COAXIAL)/ HDMI OUT jack when “DOLBY DIGITAL” is set to “D-PCM” (page 70).

DOLBY Normally, select this position.

SUR- Multi-channel audio signals are

ROUND output to 2 channels for enjoying surround sounds.

NORMAL Multi-channel audio signals are downmixed to 2 channels for use with your stereo.

◆DIGITAL OUT

Selects if audio signals are output via the DIGITAL OUT (OPTICAL or COAXIAL)/ HDMI OUT jack.

ON Normally select this position. When you select “ON,” see “Setting the digital output signal” for further settings.

OFF The influence of the digital circuit upon the analog circuit is minimal. If you are using the HDMI OUT jack, PCM sound will be output depending on the connected equipment. If the signal is encrypted for copyright protection purposes, the signal is only output as 48 kHz/16 bit PCM.

Setting the digital output signal

Switches the method of outputting audio signals when you connect a component such as an amplifier (receiver) or MD deck with a digital input jack.

For connection details, see page 20. Select “DOLBY DIGITAL,” “MPEG,” “DTS,” and “48kHz/96kHz PCM” after setting “DIGITAL OUT” to “ON.”

If you connect a component that is incompatible with the selected audio signal, a loud noise (or no sound) may be heard from the speakers, risking damage to your ears or speakers.

Notes

•The AV SYNC function (page 49) is not effective if you use the DIGITAL OUT (OPTICAL or COAXIAL) jack, and set “DOLBY DIGITAL,” “MPEG” or “DTS” to “DOLBY DIGITAL,” “MPEG” or “ON” respectively.

•The AV SYNC function (page 49) is not effective if you connect a Dolby Digital or DTS-compliant device via the HDMI OUT jack, and set “DOLBY DIGITAL,” “MPEG” or “DTS” to “DOLBY DIGITAL,” “MPEG” or “ON” respectively.

◆DOLBY DIGITAL (DVD VIDEO/DVD-VR mode only)

Selects the type of Dolby Digital signal.

D-PCM	Select this when the player is
	connected to an audio
	component without a built-in
	Dolby Digital decoder. You can
	select whether the signals
	conform to Dolby Surround
	(Pro Logic) or not by making
	adjustments to the
	“DOWNMIX” item in
	“AUDIO SETUP” (page 69).

DOLBY	Select this when the player is
DIGITAL	connected to an audio
	component with a built-in
	Dolby Digital decoder.

Note

If the HDMI OUT jack is connected to equipment not compatible with DOLBY DIGITAL signals, the “D-PCM” signals will be automatically output even when you select “DOLBY DIGITAL.”