Sony DVP-NS999ES Hooking Up the Player, Step 1: Connecting the Video Cords

Hookups

Hooking Up the Player

Follow steps 1 to 4 to hook up and adjust the settings of the player.

Before you start, disconnect the power cords, check that you have all of the supplied accessories, and insert the batteries into the remote (page 17).

Notes

•Plug cords securely to prevent unwanted noise.

•Refer to the instructions supplied with the components to be connected.

Step 1: Connecting the Video Cords

Connect this player to your TV monitor, projector, or AV amplifier (receiver) using a video cord. Select one of the patterns A through C, according to the input jack on your TV monitor, projector, or AV amplifier (receiver). In order to view progressive signal (525p) pictures with a compatible TV, projector, or monitor, you must use pattern C.

A									C
INPUT	(yellow)				Audio/video cord	Component	COMPONENT
VIDEO						video cord	VIDEO IN
					(supplied)	(not supplied)	Y
								(green)
L							CB	(blue)
AUDIO							CR
							(red)
R
							TV, projector, or AV
TV, projector, or AV							amplifier (receiver)
amplifier (receiver)
		(yellow)				(green) (blue)	(red)
to VIDEO OUT							to COMPONENT
							VIDEO OUT
1 or 2
	DIGITAL OUT		AUDIO OUT		5.1CH OUTPUT
	PCM/ DTS/		1	2	FRONT REAR CENTER
				L
	MPEG/ DOLBY DIGITAL				L
	COAXIAL	OPTICAL
					COMMAND MODE
					1 2 3
					R
				R	WOOFER
	2	2	Y	PB/CB	PR/CR SELECTABLE
					INTERLACE
					PROGRESSIVE
	1	1
	VIDEO	S1 VIDEO			SCAN SELECT		CD/DVD player
	OUT	OUT		COMPONENT VIDEO OUT
			to S VIDEO OUT 1 or 2
							INPUT
							S VIDEO
					S VIDEO cord		TV, projector, or AV		B
					(not supplied)
							amplifier (receiver)

l: Signal flow

Hookups

,continued 21