Note
The setting for this function cannot be changed during actual signal transmission. To change the setting, turn off the transmitter first. Then, while holding down the SET button, turn the power on. And then, change the setting after the signal transmission has stopped.
Note
The setting for this function cannot be changed during actual signal transmission. To change the setting, turn off the transmitter first. Then, while holding down the SET button, turn the power on. And then, change the setting after the signal transmission has stopped.
Setting the RF output
power (RF POWER)You can set the RF output power.
1 mW (LOW): Transmitted by 1 mW
10 mW (MID): Transmitted by 10 mW
50 mW (HIGH): Transmitted by 50 mW
Using wireless remote control, this function can be controlled from the receiver and other devices.
For details on wireless remote control function, see “Using the Wireless Remote Control Function” on page 20.
Setting the audio input
level (INPUT LEVEL)You can set the input level to an analog head amp.
Select LINE or MIC, depending on the audio source connected to the audio input connecter.
When MIC is selected, ATT (attenuation level) will flash next. With the microphone connected, speak into the microphone as you monitor the audio input level meter and press the + or – button repeatedly to select the appropriate attenuation level.
The reference levels for the various settings are as follows:
| Input | Attenuation | Reference input | Maximum input | Headroom (dB) |
| (dB) | level (dB) | level (dBu) |
|
MIC | 0 | 36 | ||
|
|
|
|
|
| 3 |
| ||
|
|
|
|
|
| 6 |
| ||
|
|
|
|
|
| 9 |
| ||
|
|
|
|
|
| 3 dB step | 3 dB step | 3 dB step |
|
|
|
|
|
|
| 45 | +23 |
| |
|
|
|
|
|
| 48 | +24 | 34 | |
|
|
|
|
|
LINE | – | +4 | +24 | 20 |
|
|
|
|
|
With the wireless remote control function, the attenuation level can be changed from the receiver and other devices.
For details on wireless remote control function, see “Using the Wireless Remote Control Function” on page 20.
Setting Menus 27