Shooting
3 Set the cycle to capture the image within the range from
The image is captured into memory in cycles as set in step 3.
Note
When the cycle to capture the image within the range from
To capture the image into memory using an external pulse
To capture the image into memory according to an external pulse input to the EXT CTRL connector on the rear panel, make the following menu settings.
1
2 Set “MODE” on PAGE 3 menu to the desired mode F/F or F/S.
For details of memory mode, see step 2 of “To capture to memory using an internal pulse signal” on page 33.
3 Set “EXT.CTRL(BNC)” on PAGE 3 menu to “TRIG.IN”.
4 Set “TRIGGER CYCLE” on PAGE 4 menu to “OFF”.
5 Set “TRIGGER PULSE” on PAGE 4 menu to the same polarity as the input trigger pulse.
6 Set “EXT.TRIGGER” of “SHUTTER” on PAGE 1 menu to “OFF”.
Timing of external pulse input to the EXT CTRL connector
F/F mode
Low level 0 to 0.5 V
High level 4.5 to 5.0 V
Pulse width Trigger cycle 3 V 10 ∝s to 10 mS or more
Memory Memory Memory Memory Memory
Select either of the two illustrated above.
F/S mode
Source Memory Source Memory Source
Memory: Capturing the image into memory and sending it as a still image.
Source: Chainging the output from the captured image to live image.
34