Restoring the color from the EASY or sRGB menus

The colors of most display monitors tend to gradually lose brilliance over several years of service. The IMAGE RESTORATION feature found in the EASY and sRGB menus allows you to restore the color to the original factory quality levels. The explanation below explains how to restore the monitor’s color from the EASY menu.

1Move the joystick left or right to select EASY or sRGB mode.2First move the joystick up or down to select (IMAGE RESTORATION). Then move the joystick to the right.

The picture disappears while the color is being restored (about 2 seconds). After the color is restored, the picture reappears on the screen again.

Notes

•Before using this feature, the monitor must be in normal operation mode (green power indicator on) for at least 30 minutes. If the monitor goes into power saving mode, you must return the monitor to normal operation mode and wait for 30 minutes for the monitor to be ready. You may need to adjust your computer’s power saving settings to keep the monitor in normal operation mode for the full 30 minutes. If the monitor is not ready, the following message will appear.

COLOR

EASY

EXPERT

s RGB

 

 

 

5 0 0 0 K 6 5 0 0 K 9 3 0 0 K

5 0 0 0 K

I MAGE

RES TORA T I ON

AVA I L AB L E

A F T ER WARM UP

•The monitor may gradually lose its ability to perform this function due to the natural aging of the picture tube.

Additional settings (OPTION)

You can manually degauss (demagnetize) the monitor, change the menu position, and lock the controls.

1Press the joystick.

The main MENU appears on the screen.

2Move the joystick to highlight OPTION and press the joystick again.

The OPTION menu appears on the screen.

3Move the joystick up or down to select the desired adjustment item.

Adjust the selected item according to the following instructions.

Degaussing the screen

The monitor is automatically demagnetized (degaussed) when the power is turned on.

To manually degauss the monitor, first move the
joystick up or down to select(DEGAUSS). Then
move the joystick to the right.

 

 

The screen is degaussed for about 2 seconds. If a second degauss

cycle is needed, allow a minimum interval of 20 minutes for the

best result.

 

 

 

GB

Changing the menu’s position

Change the menu’s position if it is blocking an image on the screen.

To change the menu’s on-screen position, first movethe joystick up or down to select (OSD H POSITION)

for horizontal adjustment, or (OSD V POSITION) for vertical adjustment. Then move the joystick left or right to shift the on-screen menu.

Locking the controlsTo protect adjustment data by locking the controls, first

move the joystick up or down to select (CONTROL LOCK). Then move the joystick to the right, to select ON.

Only the 1 (power) switch, EXIT, and (CONTROL LOCK)

of the OPTION menu will operate. If any other items are

selected, the mark appears on the screen.

To cancel the control lock

Repeat the procedure above and set (CONTROL LOCK) to OFF.

15