5Press the g or G button to make RATIO [OFF] blink.

6Press the Fn button.

• [CTRL+] or [CTRL] is displayed.

Off-camera flash setting:

Set the wireless flash while the flash unit is attached to the camera, and then remove it from the camera. For details, refer to the operating instructions supplied with the external flash. When the HVL-F58AM is used as the off- camera flash, see page 63, and set the remote mode to [RMT].

2Attach the controller to the camera, and turn on the power of the camera, controller, off-camera flash.

3Set up the camera with the controller and the off- camera flash.

See page 55 for details.

4Make sure that the controller and the flash unit are fully charged.

When the flash unit is fully charged in the wireless flash mode, the AF illuminator on the front blinks, and the TEST button is lit in amber.

5Use test-flash to check the flash.

The test-flash method differs depending on the camera used. For details, refer to the operating instructions of your camera.

If the test-flash does not work, change the position of the camera, flash, and subject, or point the wireless control-signal receiver towards the camera. Moreover, make sure that wireless channel of the off-camera flash is set to the same channel as the controller.

Applications

65