Sony J-10, J-10SDI, J-30 1,2,3, 1,2,3

Playback 4 Chapter

4-1 Playback Procedures
4-1-2 Playback in Jog Mode
		4-1-3 Playback in Shuttle Mode
1
	1

1,2,3 3 1,2,3

In jog mode, the JOG dial controls the playback speed based the speed at which the dial is turned. The playback speed range is ±1 times normal speed.

Use the following procedure to carry out playback in jog mode.

1 Turn the JOG dial directly or press the JOG/ SHUTTLE button to light the JOG indicator.

Pressing the JOG/SHUTTLE button toggles between jog mode and shuttle mode.

2 Turn the JOG dial in the desired direction, at a speed corresponding to the desired playback speed.

Playback in jog mode starts.

3 To stop playback in jog mode, stop turning the JOG dial.

It is possible to make pressing the JOG/SHUTTLE button to switch between JOG and SHUTTLE mode.

Select “KEY” in SELECTION FOR JOG/ SHUTTLE DIAL ENABLE, extended menu item 101, to enable the above feature. (This is the default setting.)

In shuttle mode, the SHUTTLE dial controls the playback speed based on the angular position of the dial.

•When using a Digital Betacam tape: ±21 times

•When using an MPEG IMX tape: ±32 times/±38 times (NTSC/PAL)

•When using a Betacam SX tape: ±35 times

•When using an analog Betacam tape: ±18/±20 times (NTSC/PAL)

+indicates forward direction speed, – indicates reverse direction speed.

The SHUTTLE dial has detents at the center position, move the SHUTTLE dial to the center indent to display a still picture.

Use the following procedure to carry out playback in shuttle mode.

1 Turn the SHUTTLE dial directly or press the JOG/ SHUTTLE button twice to light the SHTL indicator.

If the SHUTTLE dial points to a position other than the center, playback in shuttle mode starts at a speed corresponding to the angular position of the dial.

Pressing the JOG/SHUTTLE button toggles between jog mode and shuttle mode.

4-2Chapter 4 Playback