4-3 Using the Remote Commander

Pull off the transparent film covering the battery parts.

4-3-1 How to Change the

Lithium Battery

1 Pull out the lithium battery case.

Pull the battery case toward you while releasing the lock by plucking it with your fingernail.

2 Set lithium battery in the case so that the + symbol on the battery is facing you.

3 Push the lithium battery case back into its original position.

Notes on the Remote Commander

•If there is an obstacle between the Remote Commander and the remote control detector, the Remote Commander sometimes does not work properly. Point the Remote Commander at the remote control detector on the front side of the unit.

•The effective remote control area is limited. It becomes easier to control the unit the closer you get and if you point the Remote Commander directly at the front of the unit.

•Change the battery when the Remote Commander does not work properly.

4-3-2 Setting Menu

When a Remote Commander is used, WIRELESS REMOTE CONTROL, extended menu item 213, must to be set to ON. (It is set to OFF at the factory.)

(The following operation is an example of how WIRELESS REMOTE CONTROL is switched from OFF to ON.)

1 Select WIRELESS REMOTE CONTROL, extended menu item 213, to display it.

The illustration shows the information displayed in the time data display area and on the monitor connected to the COMPOSITE (SUPER) output connector, SDI (SUPER) output connector (for J- 10SDI/30SDI only) or DV connector.

Time data display area

Monitor screen

REMOTE INTERFACE

137

❉213:WIRELESS-off 501

Items without ❉ are omitted.

Playback 4 Chapter

Chapter 4 Playback 4-7