Other Info
Problem | Possible Remedies |
How to restore Video settings | s Press RESET on the remote control while in the Video menu (see page 100). |
to factory settings |
|
|
|
How to restore Audio settings | s Press RESET on the remote control while in the Audio menu (see page 103). |
to factory settings |
|
|
|
Cannot cycle through the other | s Be sure the Video Label option is not set to Skip (see page 113). |
video equipment connected to |
|
the TV |
|
|
|
Cannot operate menu | s If a menu option appears in gray, this indicates that the menu option is not |
| available. |
|
|
Lost password | s In the password screen (see page 109), enter the following master password: |
| 4357. The master password clears your previous password; it cannot be used to |
| temporarily unblock channels. |
| s The i.LINK STANDBY LED blinks when the signal from an i.LINK device is |
| being shown. |
|
|
LED on the display unit is lit | s The POWER ON/STANDBY LED (see page 18) lights up when the TV is turned |
| on. If the LED blinks continuously, this may indicate the TV needs a service. |
| s The TIMER LED (see page 18) indicates that the timer is set. When the timer is |
| set, this LED will remain lit even when the TV is turned off. |
| s If the STANDBY LED blinks, disconnect the AC power cord and leave the TV for |
| three minutes to check that it stops blinking. If the LED does not stop blinking, |
| contact qualified Sony personnel. |
|
|
The signal from a selected | s If you have several i.LINK devices connected and operating at once, the TV may |
i.LINK device is not being | not be able to display the signal from the selected device. Turn the other i.LINK |
displayed | devices off, and reselect the desired i.LINK device. |
|
|
124