Setup
| Cable Box | For best results, use this connection if: |
| s Your cable company scrambles all channels, which requires you to use a |
| cable box. |
| s You do not have a VCR. (If you have a VCR, see pages 33 and 35.) |
With this connection you can:
sUse the remote control to change channels coming through the cable box to the TV’s VHF/UHF jack. (You must first program the remote control for your specific cable box, see page 58.)
About Using This Connection with Dual Picture (Twin View, etc.) Features
With this connection, all channels come into the TV through your cable box and only one unscrambled signal is sent to the TV, so you cannot use the dual picture features. If some of your channels are scrambled, but others are not, consider using the “Cable Box and Cable” connection on page 29 instead.
To connect the cable box
1Connect the CATV cable to the cable box’s input jack.
2Use the supplied antenna cable to connect the cable box’s output jack to the TV’s VHF/UHF jack.
3Run the Auto Setup program, as described in “Setting Up the Channel List” on page 54.
CATV Antenna cable
cable (supplied)
Rear of Media
Receiver Unit
VHF/UHF
IN | OUT |
| Cable Box |
30