Connecting a Satellite Receiver

Disconnect all power sources before making any connections.

1 Connect the satellite antenna cable to the satellite receiver’s SATELLITE IN jack.

2 Using A/V and S VIDEO cables, connect the satellite receiver’s AUDIO and S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks (VIDEO 1 IN or VIDEO 2 IN).

Tip

If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.

3 Connect the supplied 75-ohm coaxial cable from your cable box or antenna

Connecting

to the TV’s VHF/UHF jack.

Satellite antenna

cable75-ohm coaxial

cable (supplied)

Satellite Receiver

S VIDEO

VIDEO (yellow)

S VIDEO cable

AUDIO-L (white)

(not supplied)

 

AUDIO-R (red)

Rear of TV

VHF/UHF

 

VIDEO S

1

 

 

 

VIDEO

IN VIDEO

(

 

 

MONO

L

 

)

AUDIO

 

 

R

 

Setting and TV the

A/V cable (not supplied)

Note

When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make

sure “Auto YC” in the (Setup) menu is set to “On” to view the S VIDEO input (see page 26).

Tip

Use VIDEO 1/2 on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the VIDEO 2 IN jacks for this hookup) to watch satellite TV.

27