Setting the TV
Setting the Channels
After you finish connecting your TV, you can run Auto Program to set up your channels. The Auto Setup menu appears when you turn your TV on for the first time after installing it.
To skip channels, see page 37.
1
DVD/ SAT/ POWER
MUTING VCR CABLE
MODE
PICTURE WIDE SLEEP DISPLAY
TOP MENU FAVORITES MENU
F1
F2
TV VIDEO 1/2 VIDEO 3 VIDEO 4
2
RESET FREEZE MTS/SAP
GUIDE TV/SAT
1 Press 1 (Power) on the TV.
The Auto Setup menu automatically appears on the screen when you turn on the TV for the first time.
Auto Setup
Auto Program: [CH+]
, Exit:[CH–]
First please connect
cable/antenna
2 Press CH + on the remote control or on the control panel of your TV to perform Auto Program.
When all the receivable channels are stored, the “Channel Skip/Add” menu appears.
Auto Program is set to scan cable TV channels by default. To watch VHF/UHF channels with an antenna, see “To watch VHF/UHF channels with an antenna” on page 37.
To perform Auto Program again
1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Auto Program,” then press 
.
4Press 
.
“Auto Program” appears and the TV starts scanning and presetting channels automatically. When all the receivable channels are stored, the “Channel Skip/Add” menu appears. Using this menu, you can start skipping unnecessary channels (see “To skip channels” on page 37).
5Press MENU to exit the menu screen.
To cancel Auto Program
While “Auto Program” is displayed in step 3, press MENU on the remote control.
Note
To watch cable TV channels, you have to subscribe to a cable TV company. Note that cable TV cannot be received in some areas. This TV receives cable TV channels
36