Connecting a DVD Player with S Video and Audio Connectors
Use this hookup if:
• Your DVD player does not have component (Y, PB, PR) jacks.
Tips
•If your DVD player has component video output connectors, for best picture quality, use the connection described on page 30.
•The Y, PB and PR jacks on your DVD player are sometimes labeled as Y, CB and CR, or Y,
•To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to 16:9 on your DVD player. For details, refer to the operating instructions supplied with your DVD player.
Disconnect all power sources before making any connections.
1 Using an A/V cable, connect the DVD player’s AUDIO OUT jacks to the TV’s AUDIO IN jacks.
2 Using an S VIDEO cable, connect the DVD player’s S VIDEO OUT jack to the TV’s S VIDEO IN jack (VIDEO 1 IN or VIDEO 2 IN).
Tip
If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.
| Rear of TV |
|
|
|
| VHF/UHF |
|
| S VIDEO | S | 1 |
|
| VIDEO |
|
A/V cable | VIDEO (yellow) | VIDEO | INVIDEO |
(not supplied) |
| ||
|
|
| |
|
|
| |
| ( |
|
|
| MONO | L |
|
| ) | AUDIO |
|
|
| R |
|
|
|
| |
S VIDEO cable |
|
|
|
(not supplied) |
|
|
|
DVD Player
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
“Auto YC” in the | (Setup) menu is set to “On” to view the S VIDEO input (see page 26). |
Tip
Use VIDEO 1/2 on the remote control to switch to the DVD player input.
and Connecting
the Setting
TV
31