Sony KP 53V90 Operating a Cable Box or Satellite Receiver SAT, Press TV FUNCTION. Then use

Operating a Cable Box or Satellite Receiver (SAT)

Setting the Manufacturer's Code

You can program the supplied remote control to operate a cable box or satellite receiver.

Press CODE SET, SAT/CABLE (FUNCTION), and the 0-9 buttons to enter the manufacturer’s code number (see the following chart), then press ENTER.

For example, to operate a Sony satellite receiver:

CODE SET	FUNCTION		ENTER
	SAT/CABLE	0
	8		1

Manufacturer code numbers		To operate the projection TV
(satellite receiver)		Press TV (FUNCTION). Then use the
		projection TV control buttons to control the
Manufacturer	Code number
		projection TV.
Sony	801 (preset code for
	remote control)
General Electric	802, 808	Tips z
Hitachi	805
		• If more than one code number is listed, try entering
Hughes	804
		them one by one until you come to the correct code
Panasonic	803
		for your equipment.
RCA/PROSCAN	802
Toshiba	806, 807	• If you enter a new code number, the code number
		you previously entered at that setting is erased.

Manufacturer code numbers (cable box)

Manufacturer	Code
Hamlin/Regal	222, 223, 224, 225, 226
Jerrold/G.I	201, 202, 203, 204, 205,
	222, 206, 207, 208, 218
Oak	227, 228, 229
Panasonic	219, 220, 221
Pioneer	214, 215
Scientific Atlanta	209, 210, 211
Tocom	216, 217
Zenith	212, 213

To operate the cable box or satellite receiver (SAT)

1Press SAT/CABLE (POWER) [Green Button] to turn on/off the cable box or satellite receiver.

2Press SAT/CABLE (FUNCTION).

3For other operations, refer to the operating instructions that come with the equipment.

The GUIDE and INDEX (blue-labeled) buttons can be used only with a satellite receiver.

If the remote control doesn’t work

•Try repeating the set up procedures using the other codes listed for your equipment.

•In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment’s own remote control unit.

•Whenever you remove the batteries — to replace them, for example — if too much time is taken, the code numbers may revert to the factory setting and must be reset.

49