2. DISPLAY OF STANDBY/TIMER LIGHT FLASH COUNT
2 times
4 times
5 times
Lamp ON 0.3 sec. 
Lamp OFF 0.3 sec. |
|
| Lamp OFF |
|
| 3 sec. | |
|
|
| |
|
| ||
Diagnostic Item | Flash Count* | ||
+B overcurrent | 2 times | ||
Vertical deflection stopped | 4 times | ||
White balance failure | 5 times | ||
*One flash count is not used for
3.STOPPING THE STANDBY/TIMER FLASH
STANDBY/SLEEP lamp
Turn off the power switch on the TV main unit or unplug the power cord from the outlet to stop the STANDBY/TIMER lamp from flashing.
4. SELF-DIAGNOSTIC SCREEN DISPLAY
For errors with symptoms such as "power sometimes shuts off" or "screen sometimes goes out" that cannot be confirmed, it is pos sible to bring up past occurances of failure for confirmation on the screen:
[To Bring Up Screen Test]
In standby mode, press buttons on the remote commander sequentially in rapid succession as shown below:
Screen display 
channel 5 
Sound volume – 
Power ON
Note that this differs from entering the service mode (sound volume
SELF DIAGNOSTIC |
| |||
2: |
| 0 | Numeral "0" means that no fault has been detected. | |
3: | N/A | 0 |
|
|
4: |
| 0 |
|
|
5: |
| 1 | Numeral "1" means a fault has been detected one time only. | |
101: | N/A | 0 |
|
|
|
|
|
|
|
+
).
5. HANDLING OF SELF-DIAGNOSTIC SCREEN DISPLAY
Since the diagnostic results displayed on the screen are not automatically cleared, always check the
Unless the result display is cleared to "0", the
[Clearing the result display]
To clear the result display to "0", press buttons on the remote commander sequentially as shown below when the diagnostic screen is being displayed.
Channel 8 
ENTER
[Quitting Self-diagnostic screen]
To quit the entire
— 5 —
