Symptom

Cause and remedy

Short beep sound is heard.

,The headphones cannot receive infrared rays from the processor.

Turn on the processor.

Check the connection between the processor and the AC power adaptor, between the AC power adaptor and the AC power socket.

Check if there is an obstacle between the processor and the headphones.

Use the headphones nearer to the processor.

Change the position or angle of the processor.

Check if your hand or hair covers the infrared signal sensor of the headphones.

If you use the headphones near a window exposed to direct sunlight, draw a curtain or a blind to block the sunlight. Or use the headphones where you are not exposed to the direct sunlight.

If you use this system near a plasma display panel, move away from it.

Long beep sound

,The batteries of the headphones are exhausted. Pull up the self-adjusting

is heard

band and if the POWER indicator is flashing, charge the rechargeable batteries

 

or replace the alkaline batteries. If the POWER indicator is still flashing and

 

beep sound is still heard, take the unit to your nearest Sony dealer.

 

 

The surround

,Press the OUTPUT button to select VIRTUAL SURROUND mode (page 18,19).

sound effect is

,The audio being played is not a multichannel signal.

not obtained

The surround effect does not work for monaural sound sources.

 

 

The sound from the ,Face forward (e.g. to your TV) and press the RESET button on the

headphones seems

headphones.

to be different from

 

the actual direction

 

of your TV.

 

 

 

The DOLBY

,The digital audio output setting for the DVD player (including game

DIGITAL indicator

machines) may be set to “PCM”.

does not turn on

Refer to the operating instructions supplied with the DVD player, and change

 

the setting (such as “Dolby Digital/PCM” or “Dolby Digital”) for usage with

 

components having built-in Dolby Digital decoders.

,Playback signals are not recorded in Dolby digital format.

,The audio for the chapter being played is not a Dolby Digital signal.

DTS indicator light ,The DTS digital output setting on the DVD player (including game machines)

does not turn on is set to OFF. Refer to the operating instructions supplied with the DVD player, and set the DTS digital output setting to ON.

,Playback signals are not recorded in DTS format.

,The audio for the chapter being played is not a DTS signal.

,The DVD player does not support DTS format. Use a DVD player that supports DTS.

MPEG-2 AAC ,Playback signals are not recorded in MPEG-2 AAC format. indicator does not

light up.

26GB

 

Additional Information