7Adjust the volume.
Raise the | Lower the |
volume | volume |
Notes
•When watching films, be careful not to raise the volume too high in quiet scenes. You may hurt your ears when a loud scene is played.
•You may hear some noise when you disconnect the AC power adaptor from the processor before removing the headphones.
Transition time between modes
When sliding switches on the processor to change to new modes, the transition time between modes may vary. This is due to differences in system control between modes.
The headphones automatically turn off when they are removed
— Auto Power On/Off function
Do not pull up the
A repeated beep sound is heard if reception conditions deteriorate when the headphones are outside the signal transmission area, or another wireless apparatus using 2.4 GHz frequency or microwave oven causes interference. If the beep sound does not stop after moving closer to the processor, let the processor detect the optimum frequency for transmission again following the procedure below.
1 Press TUNE/ID SET on the processor once.
The RF indicator blinks and the processor detects the optimum frequency automatically. After detection is completed, the RF indicator lights up and emission starts.
2 Press TUNE/ID SET on the headphones once.
The headphones detect the frequency of the processor automatically. The beep sound stops when the headphones start receiving signals.
(Continued)
Operation 21US