Symptom

Cause and remedy

 

 

The DOLBY PRO

,The EFFECT switch on the processor is set to “OFF.”

LOGIC II indicator

,Analog input signal, digital input PCM signal, Dolby Digital 2-channel signal

does not turn on

or MPEG-2 AAC 2-channel signal is not input.

 

 

 

The DOLBY PRO

,The EFFECT switch on the processor is set to “CINEMA” or “MUSIC” mode.

LOGIC II indicator

,Analog input signal, digital input PCM signal, Dolby Digital 2-channel signal

turns on

or MPEG-2 AAC 2-channel signal is input.

 

The DTS indicator ,The DTS digital output setting on the DVD device (including game machines)

does not turn on

is set to “OFF.”

 

• See the instruction manual of your DVD device, and change the DTS digital

 

output setting to “ON.”

 

,Playback signals are not recorded in DTS format.

 

,The audio for the chapter being played is not a DTS signal.

 

,The DVD device does not support DTS format.

 

• Use a DVD device that supports DTS.

 

 

MPEG-2 AAC

,Playback signals are not recorded in MPEG-2 AAC format.

indicator does not

 

light up.

 

 

 

The battery

,Check if the CHG indicator turns on. If not, put the headphones on the

cannot be

processor correctly so that the CHG indicator turns on.

charged

,Dry batteries are installed.

 

 

• Insert the supplied rechargeable nickel-metal hydride battery.

 

,Rechargeable batteries other than the supplied are installed.

 

• Insert the supplied rechargeable nickel-metal hydride battery.

 

,The processor’s contact pin and headphones’ contact point are dusty.

 

• Wipe them with a cotton bud, etc.

 

 

The CHG indicator

,3 and # of the rechargeable battery do not match those in the battery

blinks.

compartment correctly.

• Insert the rechargeable battery with correct polarity. ,The rechargeable battery is damaged.

• Replace it with a new one. The rechargeable battery, type BP-HP2000, is not commercially available. You can order the battery from the store where you purchased this system, or at your nearest Sony dealer.

RF signal transmission does not stop. (when the

INPUT SELECT switch on the processor is set to “ANALOG”)

,Signal noise is output from the connected analog component.

•Unplug the connected analog component, or set the INPUT SELECT switch on the processor to "DIGITAL," and make sure playback of the component connected to the DIGITAL IN jack is stopped.

(Continued)

Additional Information

 

27US