Sony MZ-R410, MZ-R410DPC Note, Press, To stop recording, press, To cancel synchro-recording, About the DSP TYPE-Rfor ATRAC, If the recording does not start

To stop recording, press x.

After you press x to stop, the recorder will automatically turn off in about 10 seconds (when using the dry battery) or about 3 minutes (when using the AC power adaptor).

To cancel synchro-recording

Press > or . repeatedly until “OFF” flashes in the display in step 3, and then press ENTER.

Note

If you record on a previously recorded disc, the recorder is factory set to overwrite the entire contents of the disc. If you want the recording to start after the existing contents, do the procedure “Recording without overwriting existing material” (page 24) before doing step 3, “Record an MD.” (page 14).

To	Press
Record from the end of the	If “R-Posi” (the record-starting position setting) is set to
current contents1)	“FrHere”, press END SEARCH, and then press N while
	pressing REC.1)
	If “R-Posi” is set to “Fr End”, press N while pressing
	REC.
Record over partway through	N, ., or > to find the start point of recording and
the previous recording1)	press x to stop. Then press N while pressing REC.
Pause	X2).
	Press X again to resume recording.
Remove the MD	x and open the lid.3) (The lid does not open while “Edit”
	is flashing in the display.)

1)If “R-Posi” is set to “Fr End”, recording operations will always start from the end of the previously recorded material without pressing END SEARCH button (page 25).

2)A track mark is added at the point where you press X again to resume recording while pausing; thus the remainder of the track will be counted as a new track.

3)If you open the lid while “R-Posi” is set to “FrHere”, recording will begin from the top of the disc the next time you record. Check the point to start recording on the display.

If the recording does not start

•Make sure the recorder is not locked (page 12, 44).

•Make sure the MD is not record-protected (page 61).

•Premastered MDs cannot be recorded over.

About the DSP TYPE-R for ATRAC

“TYPE-R” is a high-level Sony specification used in the Digital Signal Processor (DSP), which is the heart of the MiniDisc sound. This technology gives the MiniDisc recorder twice the signal processing capability as previous MiniDisc Walkman models, producing a sound quality close to that of MiniDisc decks. This unit supports the “TYPE-R” function only during recording or playback in normal stereo (or monaural) mode. It does not support this function in MDLP mode.

15