Messages
If the following error messages flash in the display window, check the chart below.
Error message | Meaning/Remedy |
BLANK DISC | •An MD with no recording on it is inserted. |
| b Insert a recorded MD. |
|
|
DISC ERR | •The recorder cannot read the disc (it's scratched or dirty). |
| b Reinsert or replace the disc. |
|
|
DISC FULL | •There is no more space to record on the disc (less than 12 |
| seconds available). |
| b Replace the disc. |
|
|
Data Save | •The MD player is recording information (sounds) from the |
| memory to the disk. |
| b Wait until this process is completed. Do not expose the |
| player to any physical shock, nor disrupt power supply. |
|
|
Toc Edit | •The MD player is recording information (track start and end |
| position) from the memory to the disk. |
| b Wait until this process is completed. Do not expose the |
| player to physical shock, nor disrupt power supply. |
|
|
BUSY | •You tried to operate the recorder while it was accessing the |
| recorded data. |
| b Wait until the message goes out (in rare cases, it may take |
| |
|
|
NAME FULL | •You tried to enter more than 200 characters for a track or disc |
| name or the total characters entered in an MD is more than |
| 1700. |
| b Enter the characters within the limit. |
|
|
Hi DC in | •Voltage of the power supply is too high (The supplied AC |
| power adaptor or the recommended car battery cord is not |
| used). |
| b Use the supplied AC power adaptor or the recommended |
| car battery cord. |
HOLD | •The recorder is locked. |
| b Slide HOLD against the arrow to unlock the recorder |
| (page 20). |
|
|
LOW BATT | •Batteries are weak. |
| b Charge the rechargeable battery or replace the dry |
| batteries (pages 25, 26). |
MEM OVER | •You tried to record when there is no indication in the display, |
| with the recorder placed where it receives continuous |
| vibration. |
| b Put the recorder on a stable place, and start recording |
| again. |
|
|