The b mark on the left of the selected item changes to a z mark and the z mark on the left of the setting changes to a ? mark.
4 Turn the MENU knob to select whether or not to display the selected window, then press the MENU knob.
The z mark changes to a b mark and the ? mark changes to a z mark.
5 To continue setting other windows, repeat steps 3 and 4.
6 To end the menu operation, set the MENU ON/OFF switch to OFF or close the cover of the menu operating section.
7-2-9 Confirming the Image of the
Return Video Signal in the
Viewfinder
You can set whether or not the image of the return video signal input to the GENLOCK IN connector is displayed in the viewfinder, using the GENLOCK page of the MAINTENANCE menu.
Proceed as follows.
1 Set the MENU ON/OFF switch to ON while holding down the MENU knob.
The TOP menu appears.
2 Turn the MENU knob to move the b mark to “MAINTENANCE”, then press the MENU knob.
If this is the first time the MAINTENANCE menu has been displayed, the CONTENTS page of the MAINTENANCE menu appears.
If the menu has been used before, the last accessed page appears.
3 If the CONTENTS page is displayed, turn the MENU knob to move the b mark to “GENLOCK”, then press the MENU knob to display the GENLOCK page.
If a different page is displayed, turn the MENU knob until the GENLOCK page appears, then press the MENU knob to select the page.
|
|
|
|
|
|
|
| M15 | GENLOCK |
| TOP |
| |
| GENLOCK | : | ON |
| ||
| RETURN VIDEO | : | OFF |
| ||
| GL | H | PHASE | : | 0 |
|
| GL | SC | PHASE | : | 0 |
|
| GL | SC | 0/180 | SEL : | 180 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4 Carry out setting operations as follows.
1Turn the MENU knob to move the b mark to “GENLOCK”, and press the MENU knob.
The b mark on the left of “GENLOCK” changes to a z mark and the z mark on the left of the GENLOCK setting changes to a ? mark.
2Turn the MENU knob until ”OFF” appears, then press the MENU knob.
The z mark changes to a b mark and the ? mark changes to a z mark, and the setting is executed.
3Turn the MENU knob to move the b mark to “RETURN VIDEO”, and press the MENU knob. The b mark changes to a z mark and the z mark changes to a ? mark.
4Turn the MENU knob until “ON” appears, then press the MENU knob.
The z mark changes to a b mark and the ? mark changes to a z mark, and the setting is executed.
5 To end the menu operation, set the MENU ON/OFF switch to OFF or close the cover of the menu operating section.
To see the image of the return video signal on the viewfinder screen
Hold down the RET switch on the lens. The image of the return video signal input to the GENLOCK IN connector is displayed on the viewfinder screen while you are holding down the RET switch.
When the return video function is assigned to the ASSIGN 1/3/4 switch, you can see the image of the return video signal on the viewfinder screen while you are holding down the ASSIGN 1/3/4 switch even if the RETURN VIDEO item is set to “OFF” on the GENLOCK page of the MAINTENANCE menu.
Note
When no signal is input to the GENLOCK IN connector, the image is not changed even if you hold down the RET switch on the lens.
However, the image is switched while you are holding down the ASSIGN 1/3/4 switch to which the return video function is assigned, even if no signal is input to the GENLOCK IN connector.
Settings Detailed and Displays Menu 7 Chapter
121 | |
|
|