Enter the password and press the Enter key.
The password is set to “pdw-530 (or 510)” when the unit is shipped from the factory.
The login is complete when the password is verified.
If the connection times out
This unit terminates FTP connections if no command is received within 90 seconds of the last command. If this occurs, log out (see the next section) and repeat steps 2 to 4.
Note
If you power this unit off during an FTP connection, the data transferred thus far is discarded.
5
Enter the user name “admin” and press the Enter key.
When the user name is verified, your are prompted to enter a password.
4
To log in
If this unit is connected to a remote computer with a FAM connection, first exit file operations on the FAM connection (see page 97). 1 Load a disc into this unit and put the unit into the following state.
• Recording, playback, serch, and other disc operations: Stopped
• Picture Cache function and Interval Rec function: Off
• MENU ON/OFF switch: OFF
Note
Login is not possible unless the unit is in the state described above.
2 Start the command prompt.
3 Enter “ftp <SP> <IP address>,” and press the Enter key. (<SP> refers to a space.)
For example, if the IP address of this unit is set to 192.168.001.010, enter “ftp 192.168.1.10.”
Refer to the Windows help for more information about the FTP command.
If the connection succeeds, you are prompted to enter a user name.
Operations File 6 Chapter
6-3 FTP File Operations
File operations between this unit and a remote computer can be carried out by the File Transfer Protocol (called FTP below).
A CBK-NC01 Network Adaptor (option) is required to enable file operations by FTP.
For installation and use, see the Installation Manual supplied with the CBK-NC01.
Preparations
1 Connect the network connectors of this unit and a remote computer with a network cable. Or connect this unit to the network to which the remote computer is connected.
File data | |
| Transfer of files |
PDW-510/510P/ | Laptop computer, etc. |
530/530P | |
Network cable (Cross cable, not supplied) 1)
1)To make connections to the LAN through a hub, use straight type network cables (not supplied).
2 Set the IP address and other network setting items for this unit.
For details, see 7-3-11 “Making Network Settings” (page 133).
If network settings have already been made Check the IP address of this unit.
3 Set the remote control switch to NETWORK.
Making FTP connectionsFTP connections between this unit and a remote computer can be made with either of the following.
•The command prompt
•FTP client software
This section explains how to use the command prompt. For more information about using FTP client software, refer to the documentation of the FTP client software on your system.
98 6-3 FTP File Operations