Selection Scene 4 Chapter

6 Use the SEL/SET dial or the MENU knob to move the cursor to the position where you want to move the selected sub clip.

Note

You can press the THUMBNAIL button to return to full-screen sub clip display, without moving a sub clip.

7 Press the SEL/SET dial or the MENU knob.

The sub clip thumbnail display appears, and you can check the new position of the sub clip.

Trimming a sub clip

Proceed as follows.

1 Carry out steps 1 to 4 in the procedure, “Moving a sub clip” above.

2 Use the SEL/SET dial or the MENU knob to select TRIM, and press the dial/knob.

The first frame of the selected sub clip appears. In this state, you can carry out playback and search all clips on the disc.

4 At the point where you want to set the new IN point or OUT point, select the IN (when changing the IN point) or the OUT (when changing the OUT point), and press the SEL/SET dial or the MENU knob.

To change both the IN point and the OUT point,

repeat steps 3 and 4.

New sub clips are created if the IN and OUT points span several clips after the change. The number of new sub clips equals the number of clips.

To reset the IN point or OUT point, selecting IN or OUT, hold down the RESET button and press the SEL/SET dial.

To cue up the IN point or OUT point, hold down the SHIFT button and press the NEXT or PREV button.

Note

You can press the THUMBNAIL button to return to full-screen sub clip display, without trimming a sub clip.

5 When the new IN and/or OUT points are set, hold down the SHIFT button and press the SEL/SET dial.

This carries out the trimming, and the screen returns to the sub clip thumbnail display.

To cancel the trim operation

Reset the IN point and the OUT point to return to the state before the sub clip trimming screen was displayed, then hold down the SHIFT button and press the SEL/SET dial.

This cancels the trim, and the screen returns to the sub clip thumbnail display.

To cancel the trim and escape from the sub clip trim screen

Hold down the SHIFT button and press the SEL/SET dial.

3 Carry out playback and search to find the new location of the IN point or OUT point of the selected sub clip.

Deleting a sub clip

Proceed as follows.

1 Carry out steps 1 to 4 in the procedure, “Moving a sub clip” (page 69).

2 Use the SEL/SET dial or the MENU knob to select DELETE, and press the dial/knob.

70 4-2 Basic Operations