Use manual or power zoom to set the lens to telephoto.
Set the iris to manual.

9-4 Adjusting the Flange Focal Length

If the lens does not stay in focus properly as you zoom from telephoto to wide angle, adjust the flange focal length (the distance from the plane of the lens mounting flange to the imaging plane). Make this adjustment after mounting or changing the lens.

Adjusting the flange focal length

The position of the controls for adjusting the flange focal length vary somewhat from lens to lens. Check the identification of the various controls in the lens manual.

About 3 m (10 ft)

Adjusting the flange focal length

1

2 Open the iris. Place the flange focal length adjustment chart about 3 m (10 ft) away from the camera, lit well enough to provide a satisfactory video output level.

3 Loosen the fixing screws on the F.f or F.B ring (flange focal length adjustment ring).

4

5 Point the camera at the chart by turning the focus ring and focus on it.

6 Set the zoom ring to wide angle.

7 Turn the F.f or F.B ring until the chart is in focus, being careful not to disturb the focus ring.

8 Repeat steps 4 to 7 until the chart stays in focus all the way from wide angle to telephoto.

9 Tighten the F.f or F.B ring fixing screws.

9-5 Audio Input System

9-5-1 Using the Supplied

Microphone

You can use the supplied microphone either detached from or attached to the camcorder.

Using the microphone detached from the camcorder

Connect to the MIC IN connector.

Set the AUDIO IN switch for the desired audio recording channel to FRONT.

Using the microphone detached from the camcorder

Note

When using the supplied microphone with an extension cable, always use an external power supply type cable.

Using the microphone attached to the camcorder

1 Loosen the screw and open the microphone holder clamp.

Clamp of the

Microphone holder

Camcorder the Up Setting 9 Chapter

9-4 Adjusting the Flange Focal Length / 9-5 Audio Input System

153