6 When you are finished, move the b mark to SET, then press the MENU knob.
7 Turn the MENU knob to move the b mark to “SUBNET MASK”, then press the MENU knob.
SUBNET MASK setting window appears.
8 Carry out steps 3 to 6 to set the subnet mask.
9 Turn the MENU knob to move the b mark to “DEF. GATEWAY”, then press the MENU knob.
The DEF. GATEWAY setting window appears.
10Repeat steps 3 to 6 to set the default gateway.
11To end the menu operation, set the MENU ON/OFF switch to OFF.
Setting the communications speed
Set the communications speed by choosing AUTO, 10Mbps, or 100Mbps from the menu.
The factory default setting is “AUTO”. Proceed as follows.
1 Carry out steps 1 to 3 in “Enabling automatic acquisition of the IP address” (page 133) to display the NETWORK page of the MAINTENANCE menu.
2 Turn the MENU knob to move the b mark to “LINK SPEED”, then press the MENU knob.

Settings Detailed and Displays Menu 7 Chapter

5 Turn the MENU knob to display “ENABL”, then press the MENU knob.

The z mark changes to a b mark and the ? mark changes to a z mark.

6 To end the menu operation, set the MENU ON/OFF switch to OFF.

Note

Before enabling automatic acquisition of the IP address, check to be sure that this unit is connected to a network with a network cable.

The acquired IP address is displayed in the “IP ADDRESS” line of the NETWORK page.

If an IP address could not be acquired, “0.0.0.0” is displayed. In this case, contact your network administrator.

Setting the IP address, subnet mask, and default gateway

The unit is shipped from the factory with the following settings.

IP ADDRESS: 192.168. 1.10

SUBNET MASK: 255.255.255. 0

DEF. GATEWAY: 0. 0. 0. 0 Proceed as follows to change the settings.

1 Carry out steps 1 to 3 in “Enabling automatic acquisition of the IP address” (page 133) to display the NETWORK page of the MAINTENANCE menu.

2 Turn the MENU knob to move the b mark to “IP ADDRESS”, then press the MENU knob.

The IP ADDRESS setting window appears.

3 Move the b mark to the value that you want to change, then press the MENU knob.

The b mark changes to a ? mark.

4 Turn the MENU knob to display the desired value, then press the MENU knob.

The ? mark changes to a b mark.

To cancel the change and restore the standard setting

Push the CANCEL/PRST/ESCAPE switch to the CANCEL/PRST side.

For details, see 7-1-3 “Basic Menu Operations” (page 106).

5 Repeat steps 3 and 4 to set the remaining values.

3 Turn the MENU knob to move the b mark to the desired value, then press the MENU knob.

4 To end the menu operation, set the MENU ON/OFF switch to OFF.

Setting the communications mode (full duplex or half duplex)

Set the communications speed by choosing AUTO, FULL (full duplex) or HALF (half duplex) from the menu.

The factory default setting is “AUTO”. Proceed as follows.

1 Carry out steps 1 to 3 in “Enabling automatic acquisition of the IP address” (page 133) to display the NETWORK page of the MAINTENANCE menu.

2 Turn the MENU knob to move the b mark to

“DUPLEX”, then press the MENU knob.

3 Turn the MENU knob to move the b mark to the desired mode, then press the MENU knob.

134 7-3 Adjustments and Settings from Menus