Operation limitations during FAM connections
•With the exception of the EJECT button, recording buttons and playback control buttons are disabled.
•VDR of this unit cannot be controlled from devices connected to the REMOTE connector
•There is no signal output from this unit while video is being input to this unit from external equipment.
Operating on filesProceed as follows.
1 Start Explorer.
Check that a drive letter has been assigned to this unit. (The drive letter will differ depending on the number of other peripherals connected to the remote computer.)
2 Use Explorer to perform file operations on the disc loaded in this unit.
You can operate in the same way that you operate on local drives and files on network computers.
Notes
•If you power this unit off during an FAM connection, the data transferred thus far is discarded.
•All file operations are not possible for some types of files.
For details, see
To eject discs from a remote computer
Right click the icon representing this unit in Explorer, and select Eject from the menu which appears.
Exiting file operationsProceed as follows.
Note
Do not disconnect the cable before performing steps 1 to 3.
1 Do one of the following on the or icon displayed in the remote computer’s taskbar.
•Double click.
•Right click, and select one of the following commands from the menu which appears.
-Windows 2000: Unplug or eject hardware
-Windows XP: Safely Remove Hardware
•Windows 2000: The Unplug or Eject Hardware dialog appears.
•Windows XP: The Safely Remove Hardware dialog appears.
2 Select “Sony XDCAM
The Stop a Hardware device dialog appears.
3 Select “Sony XDCAM
•Windows 2000: A confirmation message appears.
•Windows XP: “Sony XDCAM
This unit can now resume normal operations. (The limitations described in “Operation limitations during FAM connections” (see page 97) no longer apply.)
4 Disconnect the i.LINK cable as required.
ReconnectingTo reconnect after exiting file operations, do one of the following, depending on whether an i.LINK cable is connected.
i.LINK cable is not connected: Connect this unit and a remote computer with an i.LINK cable.
i.LINK cable is connected: Disconnect the i.LINK cable from either this unit or the remote computer, wait for at least 10 seconds, and then reconnect the disconnected cable.
The unit is powered off and an i.LINK cable is connected: Power the unit on.
To disable FAM connectionsExecute one of the procedures described in the previous section “Reconnecting” to make a FAM connection between this unit and the remote computer. To disable FAM connections, set the menu item PC REMOTE to “DSABL.”
For more information about how to make this setting, see “To enable FAM connections over the i.LINK connector” (page 96).
Operations File 6 Chapter
97 | |
|
|