Switching the front/rear output

— Zone × Zone

You can set to have DVD audio/video output to the rear monitor, and output another source to the front.

This function is convenient when you want to enjoy radio, music playback, etc, in the front, and DVD playback in the rear.

ATT DVD

OFF

SRC MODE

TOP MENU + MENU

SOUND

SETUP

ENTER

SYSTEM LIST –

MENU

PICTURE

Z ⋅ Z Z ⋅ Z EQ DSO EQ7

AUDIO SUBTITLE ANGLE

1 Press (ZxZ).2 Press (SOURCE) on the main unit to switch the source of the front.

Operate the front with the main unit, and the rear (DVD) with the card remote commander.

To return to normal statusPress (ZxZ).

Notes

•While Zone × Zone is activated, the following buttons on the card remote commander become inactive:

(ATT), (SRC) (SOURCE), (MODE), (VOL) +/–,(SYSTEM MENU), (LIST), (SOUND), (DSO), (EQ7).

•Zone × Zone is not cancelled even if the disc is ejected, and it will be activated when a disc is inserted again.

Additional Information

Maintenance

Replacing the lithium battery of the card remote commander

Under normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion.

+ side up

2 c 1

Notes on the lithium battery

•Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

•Wipe the battery with a dry cloth to assure a good contact.

•Be sure to observe the correct polarity when installing the battery.

•Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.

WARNINGBattery may explode if mistreated.Do not recharge, disassemble, or dispose of in fire.
Fuse replacement

 

When replacing the fuse, be

 

sure to use one matching the

 

amperage rating stated on the

 

original fuse. If the fuse

 

blows, check the power

 

connection and replace the

 

fuse. If the fuse blows again

 

after replacement, there may

 

be an internal malfunction. In

 

such a case, consult your

Fuse (10A)

nearest Sony dealer.

 

continue to next page t

39