9 Press ENTER.

The setup display for the component out jacks appears.

10 Select whether or not to use the COMPONENT VIDEO OUT jacks.

Select “On” if you are using the

COMPONENT VIDEO OUT jacks.

Otherwise, select “Off.”

11 Press ENTER.

The setup display for selecting the type of video signal output from the i LINE 1-TV jack appears.

No Disc Easy Setup

10:10

Select the Line1 Output signal.

Video

RGB

12 Select the type of signal you want to output from the i LINE 1-TV jack.

“Video”: Outputs video signals.

“RGB”: Outputs RGB signals.

Note that if you select “On” in step 10, you cannot select “RGB.”

13 Press ENTER.

The setup display for selecting the type of jack used to connect to your amplifier (receiver) appears.

No Disc Easy Setup

10:10

Is this recorder connected to an amplifier (receiver)?

Select the type of jack you are using.

Yes : LINE2 OUT(R-AUDIO-L)

Yes : DIGITAL OUT

No

14 Select the type of jack (if any) you are

using to connect to an amplifier (receiver).

 

If you did not connect an AV amplifier

 

(receiver), select “No,” then go to step 19.

 

If you connected an AV amplifier (receiver)

 

using an audio cord to the LINE 2 OUT

 

(AUDIO L/R) or AUDIO OUT L/R jacks,

Hookups

select “Yes: LINE 2 OUT (R-AUDIO-L),”

 

then go to step 19.

 

 

 

If you connected an AV amplifier (receiver)

and

using either a digital optical or coaxial cord,

Settings

15 Press ENTER.

 

 

select “Yes: DIGITAL OUT.”

 

 

 

The setup display for selecting the type of

 

Dolby Digital signal appears.

 

 

 

 

No Disc Easy Setup

10:10

 

 

 

 

 

 

 

Dolby Digital

D-PCM

Dolby Digital

16 Select the type of Dolby Digital signal you want to send to your amplifier (receiver).

If your AV amplifier (receiver) has a Dolby

Digital decoder, select “Dolby Digital.”

Otherwise, select “D-PCM.”

17 Press ENTER.

The setup display for the DTS signal appears.

No Disc Easy Setup

10:10

DTS

On

Off

18 Select whether or not you want to send a DTS signal to your amplifier (receiver), and press ENTER.

If your AV amplifier (receiver) has a DTS decoder, select “On.” Otherwise, select “Off.”

,continued 25