Controlling the Volume of Visual Components Connected to an Audio System (continued)

2While holding MUTING pressed, press VOL + or VOL –.

To set all volume controls toAMP

Press VOL + while holding MUTING pressed.

All Component Select buttons light up when you press these buttons, and then turn off when you release them.

Press and while holding VOL+, press MUTING.

TV VCR CBL DVD AMP

Volume control setting complete.

TV VCR CBL DVD AMP

To set only the audio components’ volume controls to AMP

Press VOL – while holding MUTING pressed.

Only AMP lights up when you press these buttons, and then turns off when you release them.

Press and while holding VOL–, press MUTING.

TV VCR CBL DVD AMP

Volume control setting complete.

TV VCR CBL DVD AMP

Visual components are:

TV, video cassette recorder, analog cable box, digital cable box, digital satellite, DVD player, digital video recorder

Audio components are: CD player, MD player, cassette deck, amplifier

To cancel setting, press SET.

Notes

•If you used the Learning function to program the VOL +/– or MUTING buttons to send a signal to a component, the procedure above will not change the function of the VOL +/– and MUTING buttons.

•If you set a Learning function for sending an amplifier‘s volume control signal on a Component Select button other than TV, the priority of sending the signal is also set as follows from highest to lowest priority: AMP buttontVCR buttontCBL buttontDVD button. For example, if you “teach” the AMP button and the VCR button to send the amplifier‘s volume signal, when you adjust the volume, the signals on AMP button are sent to the amplifier first. If you “teach” the AMP button to send signals of other than for an amplifier, the signals is sent to the amplifier from the VCR button.

24