1Press and while holding SET, press the SYSTEM CONTROL B button.
The SET indicator light turns on.
SET
If a System Control function (System Control Macro) has already been set on the button, the SET indicator flashes twice. The setting procedure is automatically canceled.
2Set the System Control function.
With this example, press buttons in sequence as below:
VCR 
POWER 
AMP
1 POWER
You can program up to 16 consecutive steps to on each of the SYSTEM CONTROL buttons (A – D), including the initial step of pressing switch to a Component Select button.
3Press SET to complete the programming.
The SYSTEM CONTROL button light turns off.
To program a new series of operations for those buttons which already have a control program have already been set
Erase the program (page 28).
Notes
•If you interrupt the procedure at any point for over 20 seconds, the setting mode ends and the series of commands will be programmed up to that point. In this case, clear the program (page 28) and start again from Step 1 to set the entire program from the beginning. You cannot continue programming once the setting mode ends.
•If a SYSTEM CONTROL button has already “learned” a remote control signal (page 14), you can program a System Control function (System Control Macro), but the function does will not work until you clear the Leaning function. To clear the Learning function, see “Changing or erasing the function of a “learned” button” on page 20.
•If you change the component code number (page 8) or program a new signal by using the Learning function (page 14) on a key or a button that has been programmed with a series of commands of using the System Control function, the new signal will be transmitted when you press the corresponding SYSTEM CONTROL button.
•While in setting mode, you cannot clear any operation step you have programmed. If you have programmed an incorrect operation by mistake, start again from Step 1.
•If you try to program more than 16 steps, the System Control setting mode ends, and the 16 steps you have programmed are registered. If you want to program the steps again, clear the program (page 28) and start again from Step 1.
Continued
27