Sony RS-232C manual 12th PEQ1 Frequency 13th

•Parameter

The parameter consists of the 26 bytes all the time in the order as shown in the table below.

byte	Parameter name
1st	SCENE No.
2nd-9th	INDEX
10th	REF LEVEL
11th	FUNCTION ON/OFF
12th	PEQ1 Frequency
13th	PEQ1 Q
14th	PEQ1 GAIN
15th	PEQ2 Frequency
16th	PEQ2 Q
17th	PEQ2 GAIN

byte	Parameter name
18 th	PEQ3 Frequency
19 th	PEQ3 Q
20 th	PEQ3 GAIN
21 st	PEQ4 Frequency
22 nd	PEQ4 Q
23 rd	PEQ4 GAIN
24 th	DELAY
25 th	GAIN LIMIT LEVEL
26 th	FADER LEVEL

When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.

At the same time, when you specify the scene No.(31[H] (‘1’) through 44[H] (‘D’)), parameters of the subsequent 2nd to 26th bytes are written in the scene memory.

For the method of setting the scene No. and index, refer to the GROUP FADER command (pages 29 and 30).

Method of setting the PEQ1-4 frequency, PEQ1-4 Q, PEQ1-4 Gain, Gain Limit and fader level is the same as that of the LINE 3 INPUT command. See pages 32 to 35.

Method of setting the REF LEVEL, Function ON/OFF and delay is the same as that of the LINE OUTPUT1 and 2 commands. See page 37.

For the packet example, see the example of the LINE 3 INPUT command on page 35. However, the parameter length becomes 26 bytes.

•REF LEVEL (10th byte)

This command is used to set the reference output level [dBu].

REF LEVEL
-10	30[H] (‘0’)
-5	35[H] (‘5’)
0	3A[H] (‘:’)

– 40 –