Sony RS-232C manual Line OUTPUT1,2 43H 4FH 4CH 31H,32H ‘COL1,2’

LINE OUTPUT1,2 : 43[H] 4F[H] 4C[H] 31[H],32[H] (‘COL1,2’)

This command is used to implement setup of any desired single channel of the LINE OUTPUT1 and 2.

Various setups can be memorized in the scene memories by specifying these scene Nos.

The commands that correspond to the respective channels are shown below.

CHANNEL	Command
LINE OUTPUT 1	43[H] 4F[H] 4C[H] 31[H] ‘COL1’
LINE OUTPUT 2	43[H] 4F[H] 4C[H] 32[H] ‘COL2’

•Packet format

43[H] 4F[H] 4C[H] 31[H] “parameter” 0D[H]

(In the case of LINE OUTPUT 1)

•Parameter

The parameter consists of the 47 bytes all the time in the order as shown in the table below.

byte	Parameter name	byte	Parameter name
1st	SCENE No.	28th	PEQ6 Q
2nd-9th	INDEX	29th	PEQ6 GAIN
10th	REF LEVEL	30th	PEQ7 Frequency
11th	FUNCTION ON/OFF	31st	PEQ7 Q
12th	PEQ1 Frequency	32nd	PEQ7 GAIN
13th	PEQ1 Q	33rd	PEQ8 Frequency
14th	PEQ1 GAIN	34th	PEQ8 Q
15th	PEQ2 Frequency	35th	PEQ8 GAIN
16th	PEQ2 Q	36th	PEQ9 Frequency
17th	PEQ2 GAIN	37th	PEQ9 Q
18th	PEQ3 Frequency	38th	PEQ9 GAIN
19th	PEQ3 Q	39th	PEQ10 Frequency
20th	PEQ3 GAIN	40th	PEQ10 Q
21st	PEQ4 Frequency	41st	PEQ10 GAIN
22nd	PEQ4 Q	42nd	PEQ11 Frequency
23rd	PEQ4 GAIN	43rd	PEQ11 Q
24th	PEQ5 Frequency	44th	PEQ11 GAIN
25th	PEQ5 Q	45th	Delay
26th	PEQ5 GAIN	46th	GAIN LIMIT LEVEL
27th	PEQ6 Frequency	47th	FADER LEVEL

When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.

When you specify the scene Nos.(31[H] (‘1’) through 44[H] (‘D’)), the parameters of the subsequent 2nd to 47th bytes are written in the scene memory.

For the method of setting the scene No. and index, refer to the GROUP FADER command (pages 29 and 30).

Method of setting the PEQ1-11 frequency, PEQ1-11 Q, PEQ1-11 Gain, Gain Limit level and fader level is the same as that of the LINE 3 INPUT command. See pages 32 to 35.

For the packet example, see the example of the LINE 3 INPUT command on page 35. However, the parameter length becomes 47 bytes.

– 37 –