Sony RS-232C LINE4 A-C,F R Level, MIC1/WL1 Level, LINE4 D-E L Level, MIC2/WL2 Level, MIC3 Level

ROUTING : 43[H] 52[H] 4C[H] 31[H]-38[H] (‘CRL1-8’) 43[H] 52[H] 52[H] 31[H]-32[H] (‘CRR1-2’)

This command is used to set the routing for the OUTPUT channels.

Various setups can be memorized in the scene memories by specifying these scene Nos.

The commands that correspond to the respective channels are shown below.

CHANNEL	Command
LINE OUTPUT 1	43[H] 52[H] 4C[H] 31[H] ‘CRL1’
LINE OUTPUT 2	43[H] 52[H] 4C[H] 32[H] ‘CRL2’
LINE OUTPUT 3	43[H] 52[H] 4C[H] 33[H] ‘CRL3’
LINE OUTPUT 4	43[H] 52[H] 4C[H] 34[H] ‘CRL4’
LINE OUTPUT 5	43[H] 52[H] 4C[H] 35[H] ‘CRL5’
LINE OUTPUT 6	43[H] 52[H] 4C[H] 36[H] ‘CRL6’
LINE OUTPUT 7	43[H] 52[H] 4C[H] 37[H] ‘CRL7’
LINE OUTPUT 8	43[H] 52[H] 4C[H] 38[H] ‘CRL8’
REC OUT 1	43[H] 52[H] 52[H] 31[H] ‘CRR1’
REC OUT 2	43[H] 52[H] 52[H] 32[H] ‘CRR2’

•Packet format

43[H] 52[H] 4C[H] 31[H] “parameter” 0D[H]

(In the case of LINE OUTPUT1)

•Parameter

The parameter consists of the 20 bytes all the time in the order as shown in the table below.

byte	Parameter name	byte	Parameter name
1st	SCENE No.	11 th	LINE4 A-C,F R LEVEL
2nd	MIC1/WL1 LEVEL	12 th	LINE4 D-E L LEVEL
3rd	MIC2/WL2 LEVEL	13 th	LINE4 D-E R LEVEL
4th	MIC3 LEVEL	14 th	LINE4 D-E LS LEVEL
5th	MIC4 LEVEL	15 th	LINE4 D-E RS LEVEL
6th	MIC5/LINE1 LEVEL	16 th	LINE4 D-E C LEVEL
7th	MIC6/LINE2 LEVEL	17 th	LINE4 D-E SW LEVEL
8th	LINE3 L LEVEL	18 th	MIC1/WL1-MIC6/LINE2 ON/OFF
9th	LINE3 R LEVEL	19 th	LINE3-LINE4A-C ON/OFF
10th	LINE4 A-C,F L LEVEL	20 th	LINE4 D,E ON/OFF

When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.

At the same time, when you specify the scene No.(31[H] (‘1’) through 44[H] (‘D’)), parameters of the subsequent 2nd through 20th byte are written in the scene memory.

For the method of setting the scene No., see the GROUP FADER command (pages 29 and 30).

– 54 –