Sony RS-232C manual REC OUT Parameter Request 52H 4FH 4DH 33H,32H ‘ROR1,2’

REC OUT PARAMETER REQUEST : 52[H] 4F[H] 4D[H] 33[H],32[H] (‘ROR1,2’)

This command is used to read parameter of the desired single channel of the REC OUT 1 and 2 from the SRP-X700P. The commands that correspond to the respective channels are shown below.

CHANNEL	Command
REC OUT 1	52[H] 4F[H] 52[H] 31[H] ‘ROR1’
REC OUT 2	52[H] 4F[H] 52[H] 32[H] ‘ROR2’

•Packet format

52[H] 4F[H] 52[H] 31[H] “parameter” 0D[H]

(In the case of REC OUT 1)

•Parameter

Specify the scene No. of the scene memory that you want to read, as the parameter.

Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.

•Return packet format

When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the order shown below.

41[H] “parameter” 0D[H]

The parameter is the same as the 9 bytes of the REC OUT1, 2 commands’ parameter from which the scene No. is exempted.

REMOTE : 43[H] 53[H] 49[H] 4F[H] (‘CSIO’)

This command is used to set the CONTROL S OUTPUT and the PROJECTOR CONTROL.

•Packet format

43[H] 53[H] 49[H] 4F[H] “parameter” 0D[H]

•Parameter

The parameter consists of the 24 bytes all the time in the order as shown in the table below.

The 24th byte should always be set to the fixed value (30[H] (‘0’)).

byte		byte
1st	LINE3 MACHINE TYPE	13th	LINE4F MACHINE TYPE
2nd	LINE3 CONNECTED CHANNEL	14th	LINE4F CONNECTED CHANNEL
3rd	LINE4A MACHINE TYPE	15th	CONTROL S I/F TYPE
4th	LINE4A CONNECTED CHANNEL	16th	PJ CONTROL
5th	LINE4B MACHINE TYPE	17th	LINE4 A SIGNAL DEFINE
6th	LINE4B CONNECTED CHANNEL	18th	LINE4 B SIGNAL DEFINE
7th	LINE4C MACHINE TYPE	19th	LINE4 C SIGNAL DEFINE
8th	LINE4C CONNECTED CHANNEL	20th	LINE4 D SIGNAL DEFINE
9th	LINE4D MACHINE TYPE	21st	LINE4 E SIGNAL DEFINE
10th	LINE4D CONNECTED CHANNEL	22nd	LINE4 F SIGNAL DEFINE
11th	LINE4E MACHINE TYPE	23rd	PROJECTOR PROTOCOL
12th	LINE4E CONNECTED CHANNEL	24th	30[H] (‘0‘) fixed

– 51 –