43GB
Troubleshooting
The unit turns off automatically.
• The unit enters the selected standby mode
when it is idle for 30 minutes. If the unit is
being discharged and it is idle for another
30 minutes in the network standby mode,
the unit enters another standby mode that
saves the battery life.
There is no sound.
•Press the VOLUME + button to turn up the
volume. The unit may have been set to
silence the sound by a controller. If the
sound is output for a moment and then is
silenced again, the unit may have received
a command to silence the sound. Confirm
the setting of the controller and release
deleting the sound.
• When the PARTY STREAMING
indicator lights up in amber, confirm the
audio format of the audio content that is
being played by the PARTY host. The unit
stops playback when the PARTY host
plays audio content with an audio format
that cannot be played on the unit.
The sound skips.
•The sound may skip depending on the
network environment, etc., when you use a
wireless network.
• The servers are overloaded. Close all other
applications you are currently using.
There is severe humming, noise , or
sound distortion from the speakers.
•Connect the unit and other devices
correctly. See page11.
The unit cannot connect to the
network. (The unit cannot be found or
recognized by other devices that are on
the home network.)
• If you use the unit in a network
environment without a router, it may take
about a minute for the unit to obtain its IP
address after you turn on the power.
• The IP address may be in use by another
device when you use a fixed IP address.
Use a different IP address in this case.
The unit cannot connect to the network
via a wireless LAN connection.
• Make sure a network (LAN) cable is not
connected to the unit. The unit
automatically tries to connect to the
network over a wired LAN connection
when a network (LAN) cable is connected
to the unit.
• Confirm that the access point (wireless
LAN router) setting is correct. For details
on the access point setting, refer to the
operating instructions of the access point.
The unit cannot connect to the WPS via
a wireless LAN connection.
• You cannot connect to a network using
WPS when your access point is set to
WEP. Set up your network after searching
the access point using the access point
scan.
The browser screen does not appear.
•Check the proxy setting of the browser.
This unit does not support proxies. Change
the browser setting to one connecting this
unit without a proxy.
•Check the set-up of the firewall of the
security software. Refer to the web site
(page42) for details.
Sound outputNetworkBrowser