18
Press TEST TONE again to turn off the test tone.
6
Repeat Steps 3 and 4 to adjust other parameters within <<LEVEL>>.
If you do not operate the remote for a few seconds, the value turns off and is stored in the system.
5
You will hear the test tone from each speaker in sequence.
2 Press LEVEL.
3 Sit at your listening position and select the item to be adjusted using the M/m buttons.
• Items adjusted in << LEVEL >>
– Balance of the front and rear speakers
– Volume level of the center and rear speakers and subwoofer
You will also find other <<LEVEL>> items (dts LFE, and D.COMP.), that you do not have to adjust here yet. They are to be used when you customize sound fields. See page 25.
4 Adjust the volume level so that the volume of the test tone from each speaker sounds the same using the </, buttons.
The adjusted value will appear on the front panel display.
Press TEST TONE on the remote.
1
Press </, to change between R.HEIGHT LOW and
R.HEIGHT HIGH.
• R.HEIGHT LOW
Select this if the rear speakers are located in the section D.
• R.HEIGHT HIGH
Select this if the rear speakers are located in the section C.
To specify the balance and level of the speakers
Speaker Setup
Height diagram
C
D

Started Getting

C

60

D

30

xBALANCE

You can vary the balance of each speaker as follows. The default adjustments are in the parentheses.

•FRNT. L ____ R (center) (front speakers)

Adjust the balance between the front left and right speakers (6 dB (L) to 6 dB (R), 1 dB steps).

•REAR L ____ R (center) (rear speakers)

Adjust the balance between the rear left and right speakers (6 dB (L) to 6 dB (R), 1 dB steps).

xLEVEL

You can vary the level of each speaker as follows. The default adjustments are in the parentheses.

•C. LEVEL (0 dB) (center speaker level)

Adjust the level of the center speaker (–6 dB to +6 dB, 1 dB steps).

•R. LEVEL (0 dB) (rear speakers level)

Adjust the level of the rear speakers (–6 dB to +6 dB, 1 dB steps).

•S. W. LEVEL (0 dB) (subwoofer level)

Adjust the level of the subwoofer (–6 dB to +6 dB, 1 dB steps).

Note

When you select an item, the sound cuts off for a moment.

To adjust the volume of all the speakers at one time

Use the MASTER VOLUME +/– buttons.