Step 3: Connect the power cord

With the media engine, display, and computer switched off, first connect the power cord to the media engine, then connect it to a power outlet.

to AC IN

to a power outlet

power cord (supplied)

Step 4: Turn on the monitor and computer

1Turn on the media engine.

The display automatically turns on. The indicators of the media engine and display light up in green.

2Turn on the computer.

The installation of your monitor is complete. If necessary, use the monitor’s controls to adjust the picture.

If no picture appears on your screen

•Check that the monitor is correctly connected to the computer.

•Check that the media engine is on.

•If NO INPUT SIGNAL appears on the screen, the computer is in the power saving mode. Try pressing any key on the keyboard or moving the mouse.

•If CABLE DISCONNECTED appears on the screen, try changing the input signal (page 10), and check that the video input cable is properly connected.

•If OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphic board so that the horizontal frequency is between 30 – 61 kHz, and the vertical frequency is between 48 – 85 Hz (only XGA mode at 75 Hz).

For more information about the on-screen messages, see “Trouble symptoms and remedies” on page 20.

For customers using Windows 95/98

 

To maximize the potential of your monitor, install the new model

 

information file from the supplied Windows Monitor Information Disk

 

onto your PC.

 

This monitor complies with the “VESA DDC” Plug & Play standard. If

 

your PC/graphics board complies with DDC, select “Plug & Play Monitor

 

(VESA DDC)” or this monitor’s model name as the monitor type in the

 

“Control Panel” of Windows 95/98. If your PC/graphics board has

 

difficulty communicating with this monitor, load the Windows Monitor

 

Information Disk and select this monitor’s model name as the monitor

 

GB

type.

 

For customers using Windows NT4.0

 

Monitor setup in Windows NT4.0 is different from Windows 95/98 and

 

does not involve the selection of monitor type. Refer to the Windows

 

NT4.0 instruction manual for further details on adjusting the resolution,

 

refresh rate, and number of colors.

 

Adjusting the monitor’s resolution and color number

 

Adjust the monitor’s resolution and color number by referring to your

 

computer’s instruction manual. The color number may vary according to

 

your computer or video board. The color palette setting and the actual

 

number of colors are as follows:

 

• High Color (16 bit) t 65,536 colors

 

• True Color (24 bit) t about 16.77 million colors

 

In true color mode (24 bit), speed may be slower.

 

9