![](/images/new-backgrounds/1038669/3866939x1.webp)
Setting Up the Remote for
5Click the respective component.
IR CODE SETTING |
| |
MAKER | Sony | OTHER |
OUTPUT | IR |
|
VCR | DVD | TAPE |
TV | LD | DAT |
| CD | MD |
RETURN | START | EXIT |
•If the component is not a VCR or laser disc player
1Cover the IR sensor on the component to prevent accidental operation during the registration procedure.
2Click START, then go to step 6.
•If the component is a VCR, DVD or laser disc player:
1 | Click START. |
|
|
| A list of other manufacturers appears. | ||
|
| LD | DAT |
|
| CD | MD |
| RETURN | START | EXIT |
2 | Click the manufacturer of the component you | ||
| want. |
|
|
| The IR codes for that component are | ||
| automatically registered. |
|
VCR MAKER SETTING |
| ||
EMERSON | 1 2 3 4 | AKAI | 1 2 |
FISHER | 1 2 3 | GE | 1 2 |
PANASONIC | 1 2 | JVC | 1 2 |
TOSHIBA | 1 2 | RCA | 1 2 |
MITSUBISHI | 1 2 3 | SANYO | 1 2 |
GRUNDIG |
| SHARP |
|
HITACHI |
| ZENITH |
|
PHILIPS |
| OTHER |
|
RETURN | TEST |
| EXIT |
If the manufacturer is not listed, cover the IR sensor on the component to prevent accidental operation during the registration procedure, click OTHER, then go to step 6.
3Click TEST.
If the selected component turns on, the IR codes have been registered. The registration is complete.
If the component does not turn on: Click the number button beside the manufacturer’s name to select another number, then click TEST again.
If the component still does not turn on: Cover the IR sensor on the component to prevent accidental operation during the registration procedure is complete, click OTHER, then go to step 6.
6When “PUSH YOUR REMOTE” appears, press the button on your audio/video component's remote that corresponds to the control button highlighted.
is the POWER switch.
After you have registered all the IR codes, the IR CODE SETTING menu reappears.
|
| IR CODE SETTING |
|
| |||
0 | ( | ) | p | P | = + | 1 | |
2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 |
10/0 | >10 | DISC |
| TRACK | ENTER | ||
D. SKIP |
|
|
|
|
|
| |
| PUSH | YOUR | REMOTE |
| |||
|
|
|
| CODE CLEAR |
| ||
RETURN |
|
|
|
| EXIT |
LEARNING
SENSOR
audio/video component's remote
When registering the IR code, be sure to do the following; otherwise, the IR code may not be registered correctly.
•Point the remote at the LEARNING SENSOR on the receiver from a distance of less than 4 inches (10 cm).
•Hold down the button on the remote for about 2 or 3 seconds until the “RECEIVING” display switches to
“RELEASE YOUR REMOTE”.
•Keep the remote pointed horizontally at the LEARNING SENSOR until the code is registered.
7Repeat steps 3 to 6 to register IR codes from other components.
20