Press MAIN MENU repeatedly to select “CUSTOM”.

Advanced settings

Using the CUSTOMIZE menu to adjust the receiver

You can adjust various receiver settings using the CUSTOMIZE menu.

1

2 Turn MENU to select the parameter you want to adjust.

For details, see “CUSTOMIZE menu parameters” below.

3 Turn –/+ to select the setting you want. The setting is entered automatically.4 Repeat steps 2 and 3 to adjust the other items.CUSTOMIZE menu parameters

The initial setting is underlined.

xMENU XXX (Menu expanding)

EXP.

The advanced parameters for the SPEAKER SETUP and LEVEL menus are displayed and can be adjusted. For details on each setup item, see pages 17, 38 and the following pages.

STD

The advanced parameters for SPEAKER SETUP and LEVEL menus are not displayed.

x DTS 96/24 96 XXXX

(DTS 96/24 decoding mode)

AUTO

When a DTS 96/24 signal is input, it is played back at 96 kHz sampling frequencies.

OFF

Even when a DTS 96/24 signal is input, it is played back at 48 kHz sampling frequencies.

Notes

This parameter is valid only in A.F.D. mode (page 31). In other sound fields, this parameter is automatically set to “OFF”.

Even when a DTS 96/24 signal is input, standard 48 kHz decoding is used if any speakers are set to “SMALL” or if the sub woofer is set to “NO”.

xSB XXXX(Surround back decoding mode)

You can also press SURR BACK DECODING to select the surround back decoding mode (page 35). For details on each decoding mode, see page 36.

OFF

AUTO

ON

Note

This parameter is valid only when A.F.D. mode is selected except for Dolby Pro Logic IIx mode (page 31).

xS.F XXXX (Sound field link)

LINK

Lets you apply the last selected sound field to an input whenever it is selected. For example, if you select HALL for the SA-CD/CD input, then change to a different input and return to SA-CD/CD, HALL will automatically be applied again.

FIX

Sound field link is not activated.

xA.V.SYNC.XX (Time alignment)

Initial setting: 0 (0 ms)

Let you delay the output of audio to adjust the gap between video and audio. You can adjust from 0 (0 ms) to 20 (200 ms) in 10 ms steps.

xDEC. XXXX(Digital audio input decoding priority)

Lets you specify the input mode for the digital signal input to the DIGITAL IN jacks.

The initial setting is “DEC. AUTO” for VIDEO 3 and TV/SAT, and “DEC. PCM” for DVD, MD/TAPE and SA-CD/CD.

AUTO

Automatically switches the input mode between DTS, Dolby Digital, or PCM.

PCM

PCM signals are given priority (to prevent the interruption when playback starts). Even when other signals are input, the sound is output. However, this receiver cannot decode DTS-CD when set to “DEC. PCM”.

Note

When set to “DEC. AUTO” and the sound from the digital audio jacks (for SA-CD/CD, etc.) is interrupted when playback starts, set to “DEC. PCM”.

40GB