The surround effect cannot be obtained.

•Make sure the sound field function is on (press MOVIE or MUSIC).

•Sound fields do not function for the signals with a sampling frequency of more than 48 kHz.

Dolby Digital or DTS multi channel sound is not reproduced.

•Check that the playing DVD, etc. is recorded in Dolby Digital or DTS format.

•When connecting the DVD player, etc. to the digital input jacks of this receiver, check the audio setting (settings for the audio output) of the connected component.

Recording cannot be done.

•Check that the components are connected correctly.

•Select the source component with INPUT SELECTOR.

•Make sure that INPUT MODE is set to “ANALOG” (page 37) before recording from a digital component connected to the analog MD/ TAPE jacks.

•Make sure that INPUT MODE is set to “COAX IN” or “OPT IN” (page 37) before recording from a digital component connected to the DIGITAL OPTICAL MD/TAPE OUT jack.

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning (page 24).

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 25).

•Press DISPLAY repeatedly so that the frequency appears in the display.

RDS does not work.*

•Make sure that you are tuned to an FM RDS station.

•Select a stronger FM station.

The RDS information that you want does not appear.*

•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.

There is no picture or an unclear picture appears on the TV screen or monitor.

•Select the appropriate input on the receiver.

•Set your TV to the appropriate input mode.

•Move your audio components away from the TV.

•Connect your TV to the receiver using the same type of connecting cord as the one used to connect the receiver and video component (pages 7 and 10).

The DIGITAL OPTICAL MD/TAPE OUT jack flashes red.

• When “AUTO IN” is selected for INPUT MODE,

the jack flashes red when no digital audio signal is

input. This is depends on the INPUT MODE

Information Additional

AM

COAXIAL

ANTENNA

Ground wire (not supplied)

function, and is not a malfunction.

* Models of area code CEL, CEK only.

To ground

continued

59GB