Tip
Surround speaker position is designed specifically for implementation of the Cinema Studio EX modes. For other sound fields, speaker position is not so critical. Those sound fields were designed under the premise that the surround speakers would be located behind the listening position, but presentation remains fairly consistent even with the surround speakers positioned at a rather wide angle. However, if the speakers are pointing toward the listener from the immediate left and right of the listening position, the surround effects becomes unclear unless set to “PL. SIDE”.
Nevertheless, each listening environment has many variables, like wall reflections, and you may obtain better results using “PL. BEHD” if your speakers are located high above the listening position, even if they are to the immediate left and right.
Therefore, although it may result in a setting contrary to the above explanation, we recommend that you playback multi channel surround encoded software and select the setting that provides a good sense of spaciousness and that best succeeds in forming a cohesive space between the surround sound from the surround speakers and the sound of the front speakers. If you are not sure which sounds best, select “PL. BEHD” and then use the speaker distance parameter and speaker level adjustments to obtain proper balance.
x SLSR HGT. XXXX (Surround speaker height)*Lets you specify the height of your surround speakers for proper implementation of the surround effects of the Cinema Studio EX modes (page 33).
Initial setting: 100 Hz
Lets you adjust the bass crossover frequency of speakers in SPEAKER SETUP menu. You can adjust the bass crossover frequency from 40 Hz to 160 Hz in 10 Hz steps.
*This setup item is only available when at least one speaker is set to “SMALL” and the corresponding speaker segment flashes in the display.
B B
60
AA
30
•LOW
Select if the height of your surround speakers corresponds to section A.
•HIGH
Select if the height of your surround speakers corresponds to section B.
*This setup item is not available when the surround speaker size parameter is set to “NO”.