Sony STR-DB925 11GB, Other Hookups, Note, Black, Black, Caution, AC OUTLET* @, S-LINKCTRL A1, AC power cord, Required cords, S-LINKCONTROL A1 hookup

Other Hookups

								S-LINK CTRL A1
OPT DVD IN		TV/LD	DVD		VIDEO 1			MONITOR
	AM								+
OPT TV/LD IN				VIDEO 2				WOOFER
		S-VIDEO	S-VIDEO	OUT	IN	S-VIDEO	S-VIDEO	S-VIDEO	AUDIO
		IN	IN			OUT	IN	OUT OUT
OPT MD/DAT IN	y			VIDEO	VIDEO				OUT
		VIDEO	VIDEO			VIDEO	VIDEO VIDEO
								CTRL A1
	FM								–
	75Ω
OPT MD/DAT OUT	COAXIAL
		AUDIO	AUDIO	AUDIO	AUDIO	AUDIO	AUDIO	S-LINK
		IN	IN	OUT	IN	OUT	IN
DVD IN							L
COAX
	ANTENNA						R	A
DIGITAL
FRONT	REAR CENTER	IN	IN	RECOUT	IN	RECOUT	IN	R	+
L							L	y
	WOOFER							B
R							R	SIGNAL
								GND
	5.1 INPUT	PHONO	CD	MD/DAT		TAPE

Required cords

CONTROL A1 connecting cord (not supplied)

Black	Black
AC power cord	AC OUTLET* @

			+
			WIRELESS
R	L		REAR
			SPEAKER
			AC OUTLET
			–
	REAR	CENTER
			A
– FRONT –		+	L
			B

SPEAKERS

HookingUp @theComponents

		b
* The configuration, shape, and number of AC outlets on the rear panel
	To a wall outlet
varies according to the model and country to which the receiver is
shipped.

S-LINK CONTROL A1 hookup•If you have a S-LINK CONTROL A1-compatible Sony CD player, tape deck, or MD deck

Use a CONTROL A1 cord (not supplied) to connect the S-LINK CTRL A1 jack on the CD player, tape deck, or MD deck to the S-LINK CTRL A1 jack on the receiver. Refer to the separate manual “CONTROL-A1 Control System” and the operating instructions supplied with your CD player, tape deck, or MD deck for details.

Note

If you make CONTROL A1 connections from the receiver to an MD deck that is also connected to a computer, do not operate the receiver while using the “Sony MD Editor” software. This may cause a malfunction.

•If you have a Sony CD changer with a COMMAND MODE selector

If your CD changer’s COMMAND MODE selector can be set to CD 1, CD 2, or CD 3, be sure to set the command mode to “CD 1” and connect the changer to the CD jacks on the receiver.

If, however, you have a Sony CD changer with VIDEO OUT jacks, set the command mode to “CD 2” and connect the changer to the VIDEO 2 jacks on the receiver.

Connecting the AC power cordBefore connecting the AC power cord of this receiver to a wall outlet:•Connect the speaker system to the receiver (see page 13).•Turn the MASTER VOLUME control to the leftmost position (0).Connect the AC power cord(s) of your audio/video components to a wall outlet.

If you connect other audio/video components to the AC OUTLET(s) on the receiver, the receiver will supply power to the connected component(s), allowing you to turn the whole system on or off when you turn the receiver on/off.

Caution

Make sure that the total power consumption of the component(s) connected to the receiver’s AC OUTLET(s) does not exceed the wattage stated on the rear panel. Do not connect high-wattage electrical home appliances such as electric irons, fans, or TVs to this outlet.

11GB