Sony STR-DB925 Direct Tuning, Automatic Tuning, Broadcasts Receiving, 3Press DIRECT (or D.TUNING), Rotate FUNCTION to select the tuner, 1Rotate FUNCTION to select the tuner

To continue scanning, press TUNING (PTY SELECT) + or TUNING (PTY SELECT) – again.

39GB

4

The last received station is tuned in.

2 Press FM/AM to select the FM or AM band.

3 Press TUNING (PTY SELECT) + or TUNING (PTY SELECT) –.

Press the + button to scan from low to high; press the – button to scan from high to low.

When the receiver reaches either end of the band

Scanning is repeated in the same direction.

The receiver stops scanning whenever a station is received.

Rotate FUNCTION to select the tuner.

1

Automatic Tuning

For details on the buttons used in this section, see “Brief descriptions of buttons and controls used to receive broadcasts” on page 38.

Direct TuningUse the supplied remote to perform the following operations

For details on the buttons used in this section, see the operating instructions for the supplied remote.

1Rotate FUNCTION to select the tuner.

The last received station is tuned in.

2Press FM/AM to select the FM or AM band.3Press DIRECT (or D.TUNING).4Press the numeric buttons to enter the frequency.

Example 1: FM 102.50 MHz

1 b 0 b 2 b 5 b 0

Example 2: AM 1350 kHz

(You don’t have to enter the last “0”.)

1 b 3 b 5 b 0

If you cannot tune in a station and the entered numbers flash

Make sure you’ve entered the right frequency. If not, repeat Steps 3 and 4.

If the entered numbers still flash, the frequency is not used in your area.

5If you’ve tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception.

6Repeat Steps 2 to 5 to receive another station.

zIf you try to enter a frequency that is too precise for the tuning scale

The entered value is automatically rounded up or down.

Tuning scale for direct tuning is:

FM: 50 kHz

AM: 9 kHz

Broadcasts Receiving