Sony manual How to Use the Remote STR-DE905G, To turn on the receiver

Preparing and Using the Remote

Preventing Interference Between Multiple Remotes (STR-DE905G only)

If you use two or more receivers at the same time, interference may occur between the RF signals, causing the units to operate erratically. You can prevent this by giving all units a unique security number which distinguishes the signal of each unit from the others. Follow the procedure below to assign a security number to each unit.

1	Turn off the power to the unit.
2	Turn on the unit again while simultaneously
	holding down the PHONO, CD, and TUNER
	buttons on the front panel. “SECURITY No.”
	appears in the display. Enter a number from 0 to
	15 by pressing PHONO, CD or TUNER on the
	front panel. Make sure that the number is
	different from the security code of the other units.
3	After a few seconds, “SECURITY OK!” appears,

SECURITY Remote

NO. commander

0

1 2 3 4

1

1 2 3 4

2

1 2 3 4

3

1 2 3 4

4

1 2 3 4

5

1 2 3 4

6

1 2 3 4

7

1 2 3 4

SECURITY Remote

NO. commander

8

1 2 3 4

9

1 2 3 4

10

1 2 3 4

11

1 2 3 4

12

1 2 3 4

13

1 2 3 4

14

1 2 3 4

15

1 2 3 4

indicating that the code has been recorded.

4 Enter the same security number into the remote.

To do this, open the battery compartment and

remove the batteries. You will see a set of yellow

switches as shown below.

Yellow switches

Use the tip of a pen or some other pointed object to flip up the appropriate switches for each digit of the security number (refer to the chart on the following page). Note that all switches are down for zero, and all switches are up for fifteen.

5Reinsert the batteries and place the remote on a flat surface for about 10 seconds.

How to Use the Remote: STR-DE905G

The supplied remote lets you perform almost all of the receiver operations. Operation is simple, just move the remote in the direction you want to move the pointer (hand shaped icon) on the on-screen display. Position the pointer so that the finger tip is positioned on one of the on-screen items, then press and quickly release the button on the remote to “click” the item.

			FUNCTION
							ALL
							OFF
					Pointer
	S						VOL
	O
Blank	U						+
	N
area							–
	D
					SUB	USER
	0	(	)	p	P	=	+

Click button

To turn on the receiver

Press the click button on the remote once or twice to turn on

the unit.	(continued)	EN
		15